I have continued the engine bay teardown and have got on removing as much of the wiring loom as possible.
Various Looms
Had to pull it all through the bulkhead into the area in front of the windscreen
Loom all loose at one side.
Scuttle looking empty
Its some length of wire once its all unclipped. Hopefully I can remember how it all goes together.
And out it comes.
Full loom
Very dirty scuttle.
The remaining part of the loom. This plugs into the back of the fusebox. Not sure I want to disturb this. Leave it where it is for now.
Looking to remove servo now. Brake pipes out already.
Comes out easy enough to a point then gets stuck on pedals underneath. Note large hole in servo.
I can see the footwell.
Took off the fluid reservoir and master cylinder to make things easier.
Hmm - This has seen better days.
New one I think...
Sadly I have not been able to locate a replacement yet. Anyone any ideas?
